Beyond Pool Cleaning fixes and upgrades the circulation, filtration, heating, and control equipment behind residential pools and spas in Chandler. A lot of that equipment went in when the homes were built, and when it starts to act up, we help you sort out what needs repair, what needs replacing, and what can wait.
Call us if the spa will not heat or takes hours to warm up, if the automation panel is showing a fault code or has stopped responding, if the pump makes a whining or rattling sound, if the waterfall or sheer descent has slowed to a trickle, if the salt system reads no output or low salt when the level is fine, if water drips from a fitting or valve on the equipment pad, or if a valve actuator no longer switches between pool and spa.
All of our equipment work is done under Arizona ROC license 365989 and in partnership with Nevergreen Pools. Tell us what is going on through the request form, or call, and we will schedule a technician to diagnose it.
Pool and spa systems with automation have a lot of moving parts that depend on each other. A heater that will not fire may have a problem in the heater itself, or it may not be getting enough flow because of a dirty filter or a stuck valve. A dead salt cell may be scaled up, or the control board may be the issue. That is why we check the full system, from the skimmers and drains through the pump, filter, heater, salt system, valves, and controls, before pointing to any single part.
Once we know the cause, the repair is written up in a quote you can review. We will tell you plainly whether a repair is worth doing or whether the equipment is old enough that replacing it will cost you less over time, especially with original components that came with the house. Nothing is started without your sign off. The same team that handles your pool handles the repair, and we check back afterward to be sure everything is still running well.
Equipment in this area deals with a few recurring stresses. Many pools are from the 1990s and 2000s and have original pumps, heaters, and controls nearing the end of their service life, alongside newer automation, salt systems, and variable-speed pumps. Hard water builds scale on salt cells, heater exchangers, and spillways. Extreme summer heat means longer pump run times, and monsoon dust storms load filters and strainers, which strains the pump. With so many commuter households, a problem can run for a full day before anyone is home to see it.
Repair and replacement work includes:
After a proper repair, the pool circulates and filters on its schedule, the spa heats when you want it, the water features flow evenly, and the automation does what the app says it is doing. Because we fixed the cause and not only the symptom, the same problem is far less likely to come back. You also get a clear view of the age and condition of the rest of your equipment, so you can plan ahead instead of reacting.
Ignoring equipment problems often makes the eventual repair larger. A leaking seal can wreck pump bearings if it runs long enough. A heater forced to run with poor flow can overheat and damage its internals. A salt cell left scaled can fail outright, and the pool can lose its chlorine and turn in the middle of summer. When original equipment finally gives out during a heat wave, you are left paying for the repair and possibly a green pool cleanup on top of it.
Since you are probably at work when we come out, we keep you in the loop with photos and notes about what we found. You approve the quote by phone or email, we complete the work, and we confirm the system is running before we leave. You do not need to take time off to get your equipment fixed.
If several pieces of original equipment are aging at once, we can help you plan replacements in stages. That spreads out the cost and avoids the scramble of a summer breakdown. We will also make sure new equipment is set up properly with your existing automation so everything works together.
Need a pump, heater, or control looked at? Reach out by phone and we will book a diagnostic visit.