Beyond Pool Cleaning cleans and services pool filters in Gilbert, whether your system uses cartridges, DE grids, or sand, so the water passing back into your pool is actually getting filtered. We also check the filter housing and the parts around it so a cleaning does not hide a bigger problem.
Call us if the filter pressure gauge keeps creeping above its normal reading, if the water stays cloudy even with good chlorine levels, if the return jets feel weak, if fine dust from the last storm keeps drifting back into the pool after vacuuming, if you see DE powder or sand on the pool floor, if the cartridges look brown and matted, if you cannot remember when the filter was last opened, or if the spa jets have lost their push.
We are Arizona ROC licensed under number 365989 and serve homeowners in partnership with Nevergreen Pools. Send us the form on this page with your filter type if you know it, and we will follow up to schedule.
We start by looking at the full circulation path, not only the filter tank. The technician checks pump flow, pressure before and after the service, the condition of the valves, and whether the skimmer and pump baskets are letting enough water through. Sometimes a high gauge reading has more to do with a blocked basket or a partly closed valve than with a dirty filter.
With the system shut down, the filter is opened and cleaned according to its type. Cartridges are pulled and rinsed thoroughly, DE grids are taken out, washed, inspected for tears, and recharged with fresh powder, and sand filters are backwashed and checked for channeling or worn media. O-rings and lids get inspected so the tank seals properly when it goes back together.
If anything is past saving, such as cartridges with collapsed pleats, a torn grid, or sand that has turned to clumps, we tell you and put a written quote in front of you before replacing it. You will hear whether the part has another season in it or whether swapping it now will save the pump some strain. The same crew that does the cleaning comes back for the follow up.
Filters in this area take a beating. Monsoon dust storms from July through September can load a filter in one night, and hard water leaves calcium on cartridge pleats and DE grids that rinsing alone will not remove. Many homes here were built in the 1990s and 2000s, so some original filters are aging out, while newer pads usually run large cartridge filters paired with salt systems. Heavy family use from spring to fall adds sunscreen, lotion, and body oils that coat the media and shorten the time between cleanings.
Filter services we offer:
When the filter is clean, the whole pool works better. Water clarity improves, your chlorine does not have to fight as hard against particles and debris, and the pump moves water with less effort. Many homeowners notice that the pool looks brighter within a day and that it holds that clarity between visits instead of fading back to a haze.
A neglected filter costs you in several ways. Your pump runs against higher pressure, which raises energy use and shortens motor life. Circulation slows, leaving dead spots where algae can start. Cartridges that sit loaded with scale and oils for too long break down and need replacing sooner. In the worst cases, a cracked or failed filter lets dirt pass right back into the pool, so you are paying to run equipment that is not doing its job.
How often to clean depends on the filter type, the size of the pool, how many people swim in it, and the time of year. As a general habit, most pools here benefit from a full cleaning a few times a year, plus an extra one after a big dust storm or heavy use. If you are on our weekly service, we watch the pressure gauge on every visit and recommend a cleaning when the readings call for it rather than on a fixed calendar.
Not sure when your filter was last opened? Fill in the request form or give us a call and we will set up a cleaning.